Fcc Warning - Blaupunkt BPV 660 Manual Del Usario

FCC WARNING

This equipment has been tested and found to comply with the
limits for a Class B device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable pro-
tection against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate radio
frequency energy, and, if not installed and used in accord-
ance with instructions, may cause harmful interference with
radio communications. However, there is no guarantee that
radio interference will not occur in particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to consult the
dealer or an experienced radio/TV technician for help.
You are cautioned that any changes or modifications not ex-
pressly approved in this manual could void your authority to
operate this equipment.
Features
• Detachable front panel
• Built-in power amplifier
(max. output : 57.5W × × 4ch)
• FM/AM PLL Synthesizer tuner
• 30 Station preset memory
• Travel Store / Scan tuning
• Auxiliary input
Requires use of Blaupunkt Part 7 607 897 093 and
F00E500029.
• Optional IR Remote Controls
• CD changer control
Requires use of Blaupunkt Part F00E500029.
(IDC-A09, CDC-A08, CDC-A071, CDC-A05*)
* CDC-A05 requires use of accessory cable # 7 607 889
093, available separately.
Precautions
• Avoid installing the unit where it would be subject to high
temperatures, such as in direct sunlight or a hot air stream
from the heater, or where it would be subject to dust, dirt, or
excessive vibration.
• Do not turn on the unit if the temperature inside the car is
very high. Always cool down the unit before usage. Parking
your car in direct sunlight will result in a temperature rise.
• If the unit does not turn on, check the connections first. Then
check whether the fuse at the back of the unit is blown.
• Carefully read this manual before using the unit. If you en-
counter any problems that are not covered in this manual,
please consult the dealer where you purchased the unit or
the dealer nearest to you.
• This unit has been designed specifically for playback of
compact discs bearing the following mark. Other discs can-
not be played.
Handling Compact Discs
• Be careful when removing a compact disk after the play-
back is completed because the disk may be extremely hot.
• Do not use non-conventional discs such as heart-shaped,
octangonal discs, etc. The player could be damaged.
• Do not expose compact discs to direct sunlight or any heat
source.
• Check all compact discs before playing, and discard
cracked, scratched or warped discs.
• Wipe dirty or damp discs outward from the centre with a
soft cloth.
• Do not use any solvents such as commercially available
cleaners, antistatic spray, or thinner to clean the compact
discs.
Handling the Front Panel
Attaching the Front Panel
Place the right hand side of the front panel so that the parts
A of the front panel are engaged with the parts B of the unit
as shown below. Then push the left hand side of the front
panel until it is securely locked.
Detaching the Front Panel
Remove the CD from the unit, if any, and turn off the power of
the unit.
Press the to unlock the front panel from the unit. Grasp
REL
the front panel as shown below and remove it from the unit.
Security
To avoid theft or loss of the front panel, you can inactivate
the release button REL by installing the screw provided.
1.
Unscrew the bolt marked at the left front side of the
*
unit. (See diagram above)
2.
Attach the front panel.
3.
Select a locking screw from the mounting hardware (See
page 8) and screw it into the same hole to fasten the front
panel.
Notes
• Do not press hard on the front panel when affixing it to the
unit. No more than light to moderate pressure should be
needed.
• Make sure there is no dust or dirt on the electrical terminals
on the back of the front panel as this could cause intermitent
operation or other malfunctions.
E-1