Important Safety Instructions; Basic Setup - Fellowes 10M Manual De Instrucciones

A.
B.
C.
D.
CAPABILITIES
Will shred: Paper, plastic credit cards and staples
Will not shred: Unopened junk mail, continuous forms, adhesive labels,
transparencies, newspaper, CD/DVDs, cardboard, paper clips, laminates, file folders,
X-rays or plastic other than noted above
Paper shred size:
Micro-Cut ............................................................................................2mm x 12mm
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
in the instruction manual. Read the entire instruction manual
before operating shredders.
paper entry. Always set to off or unplug when not in use.
away from shredder openings. If object enters top opening,
switch to Reverse (
DO NOT use aerosol products, petroleum based or aerosol lubricants on
or near shredder. DO NOT USE "CANNED AIR" OR "AIR DUSTERS" ON
SHREDDER. Vapors from propellants and petroleum based lubricants
may combust causing serious injury.
shredder. Do not place near or over heat source or water.
BASIC SET UP
CASTER INSTALLATION
1
2
E.
F.
G.
) to back out object.
2 3
KEY
A. See safety instructions below G. Control Panel and LEDs
B. Paper/card entry
C. Pull-out Bin
D. Casters
E. Disconnect power switch
1. OFF
2. ON
F. Safety lock
To set lock slide
button down
Maximum:
Sheets per pass ...................................................................................................10*
Cards per pass .......................................................................................................1*
Paper width ...................................................................................................220mm
* 70g A4 paper at 220-240V, 50/60Hz, 2.3Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates:
250 sheets; 10 cards.
position to operate shredder. In case of emergency, move switch to OFF ( )
position. This action will stop shredder immediately.
amperage designated on the label. The outlet or socket must be installed
or extension cords should not be used with this product.
4
ENGLISH
Model 10M
1. Reverse
2. OFF
3. ON (white)
4. Remove paper (flashing
red) / Overheat (red)
( )