Installation Outside Of The Indoor Unit - LG PQDSBC Manual De Propietario Y De Instalación

Installation outside of the indoor unit

Anchor the rear case of Dry Contact for
communication on the installation surface at
holes using anchor screws.
Please cut the pole which is located in side of the front case properly.
Connect connection wires according to the
instructions.
(Reference to Setting and Using Method)
Then, connect wire to PCB after going
through hole of .
Perform the switch setting according to switch setting method. (Reference to Setting and Using Method)
Join the front case and the rear case, anchor
the front case at holes using anchor screws.
1. Install the product on flat surface and install anchoring screws at more than 2 places. Otherwise
the central controller may not be anchored properly.
2. Do not tighten anchoring screws too tightly. It may cause deformation of the case.
3. Do not deform the case at random. It may cause malfunction of the central controller.
Installation Method
D R Y C
O N T A
Owner's & installation manual 7
C T U N
I T