Global Settings - SYSTEMS DMP801 Manual Del Usuario

DMP801
Set via Software
When the IP address is set by software (the PIN2 of the
DIP switch is set to OFF), the screen of the Network will
be like below�
Device Name: The name of the current device is found
here� This can be adjusted by the user if necessary�
IP Address: The actual IP address of DMP801 will be
shown here�
The Network bits of the IP address is recognized
automatically and the host bits of the IP address is
configured via the combination controls on the rear pnael
manually�
Security
User Account Profile
You can create user account under this tab� Once
User Name and Password are defined, click "SAVE" to
store�

Global Settings

Analog In
Each of the analog inputs can have +48V of phantom
power applied to it, ideal for condenser microphones� This
menu also allows the user to trim the signal slightly if levels
are too excessive. A high-pass filter can also be added to
each of the analog inputs to help remove stage rumble and
other unwanted noise�
14
English