Packaging Components - San Marina Pools AR700 Manual De Instalación Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 9
MONOBLOC FILTER INSTRUCTIONS
• All electrical installations should comply with the following standard;
that refers "to the construction of electrical installations, both in indoor and outdoor swimming pools", or the equivalent
standard in force in each region or country.
• All filtering should follow the C 15-100 installation standard that stipulates that all electrical apparatus located at less
than 3.5 m. from the pool and freely accessible, should be supplied by a very low voltage of 12 V. All apparatus
supplied with 220 V should be located at least 3.5 m. from the swimming pool edge. Ask the manufacturer for
permission to make any modifications in one or more elements of the filtering system.
• The electrical installation should be performed by professional staff qualified in electrical installations.
• The height of the sand should not exceed 2/3 of the height of the tank.
• The apparatus must not be on while the pool is being used.
• Do not operate the apparatus unless it is properly primed.
• NEVER touch the filter when it is operating if you are wet or have wet hands.
• When handling the filter or valve, DISCONNECT the power supply.
• Make sure that the ground is dry before touching the electrical equipment.
• Do not install the filter where it could become wet, as it may cause electrocution.
• Do not allow children or adults to lean against or sit on the apparatus.
• If the supply flex of the apparatus is damaged, it should be replaced. Read the instructions carefully to replace it.
If in doubt, contact the technical service.

1 PACKAGING COMPONENTS

The filter which you have just purchased is a device which is especially planned and designed for elevated pools. As a
result of its innovative design and high level of functionality, it provides you with the different components required to filter
water: filter, pump and selector valve in a single unit. The main components of this filter are as follows:
AR700 / AR700C
AR700 / AR700C
AR700 / AR700C
AR700 / AR700C
AR700 / AR700C
AR705 / AR705C
AR705 / AR705C
AR705 / AR705C
AR705 / AR705C
AR705 / AR705C
AR705 / AR705C
AR705 / AR705C
AR705 / AR705C
AR705 / AR705C
AR710 / AR710C
AR710 / AR710C
AR710 / AR710C
AR710 / AR710C
AR710 / AR710C
AR710 / AR710C
AR710 / AR710C
AR710 / AR710C
AR710 / AR710C
SAFETY INSTRUCTIONS. READ CAREFULLY
NF EN 60-335-2-41
Modelo
Fig.
Pos.
1
1
1
1
1
1
1
1
1
1
13
13
13
13
1
1
1
1
1
13
13
13
13
NF C15-100
Denominacion
1
TOP selector valve
2
Filter Ø300
3
Plastic Base Ø300
4
Hose connection of Ø38 x 360
5
Protective housing
1
TOP selector valve
2
Filter Ø300
3
Plastic Base Ø300
4
Hose connection of Ø38 x 360
6
Pump 0,4cv
1
Pipe cup
2
Nut Ø 2 1/4"
3
Discharge sleeve Ø38
4
O-Ring
7
Plastic base Ø380
8
Filter Ø380
10
TOP selector valve
12
Hose connection of Ø38 x 580
13
Pump 0,6cv.
1
Pipe cup
2
Nut Ø 2 1/4"
3
Discharge sleeve Ø38
4
O-Ring
2
ENGLISH

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ar7050Ar710Ar715

Tabla de contenido