When To Refill The Rinse Aid Dispenser; Adjusting Rinse Aid Dispenser; C, Function Of Detergent - Brandy Best RED6D Manual De Instrucciones

Function of Rinse Aid
Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying.
Attention!
Only use branded rinse aid for dishwasher. Never fill the rinse aid dispenser with any other substances (e.g.
Dishwasher cleaning agent, liquid detergent). This would damage the appliance.

When to Refill the Rinse Aid Dispenser

If there is no rinse-aid warning light in the control panel, you can judge the amount of rinse-aid by the color of the
optical level indicator C located next to the cap. When the rinse-aid container is full, the whole indicator will be dark
.As the rinse-aid diminishes, the size of the dark dot decreases. You should never let the rinse aid get below 1 / 4 full.
As the rinse aid diminishes, the size of the black dot
on the rinse aid level indicator changes, as illustrated below.
Full
3 / 4 full
1 / 2 full
1 / 4 full - Should refill to eliminate spotting
Empty
1 To open the dispenser, turn the cap to the "open" (left) arrow and lift it out.
2 Pour the rinse aid into the dispenser, being careful not to overfill.
3 Replace the cap by inserting it aligned with "open" arrow and turning it to the closed (right) arrow.
NOTE:
Clean up any rinse aid split during filling with an absorbent cloth to avoid excessive foaming
!
during the next wash. Don't forget to replace the cap before you close dishwasher door.

Adjusting Rinse Aid Dispenser

Adjust lever
(Rinse)
C. Function of Detergent
Detergents with its chemical ingredients are necessary to remove dirt, crush dirt and transport it out of the
dishwasher. Most of commercial quality detergents are suitable for this purpose.
The rinse aid dispenser has six or four settings. Always start with the
dispenser set on "4". If spots and poor drying are problems, increase the
amount of rinse aid dispensed by removing the dispenser lid and rotating
the dial to "5". If the dishes still are not drying properly or are spotted, adjust
the dial to the next higher number until your dishes are spot-free. The
recommended setting is "4". (Factory value is "4".)
!
NOTE:
Increase the dose if there are drops of water or lime spots on the dishes after washing.
Reduce it if there are sticky whitish stains on your dishes or a bluish film on glassware
or knife blades.
9
C (Rinse-Aid indicator)