First Use; Switching On And Off; Infinitely Adjustable Speed Setting; Setting The Direction Of Rotation - Parkside PSBM 500 A1 Instrucciones De Utilización Y De Seguridad

T ake firm hold of the back casing
quick-action drill chuck
casing firmly shut.
2
Assembly tools for screws and nuts:
W hen using screwdriver bits, always use a
universal bit holder.
T o screw things in, always switch the changeover
switch "drill / percussion drill"
position .

First use

Q

Switching on and off

Q
When operating the hammer-action drill you can
select between intermittent or continuous operation
mode. In either mode the device functions as follows:
To switch on intermittent operation mode:
P ress the ON / OFF switch
To switch off intermittent operation mode:
R elease the ON / OFF switch
Switching continuous operation on:
P ress and hold the ON / OFF switch
and press the locking button
To switch off continuous operation mode:
P ress and then release the ON / OFF switch
Infinitely adjustable
Q
speed setting
The ON / OFF switch
6
P ressing the ON / OFF switch
speed.

Setting the direction of rotation

Q
W ith the rotational direction switch
change the rotational direction of the electrical
tool.
Before first use / First use / Servicing and cleaning
of the
3
and turn the front
1
to the right to
4
.
6
.
6
down
6
.
5
has a variable speed control.
increases the
6
you can
7
NOTE: This is, however, not possible when the
ON / OFF switch
NOTE: Hold the appliance in the direction of work.
Clockwise rotation:
P ush the rotational direction switch
right in order to drill and to screw in screws.
Anticlockwise rotation:
P ush the direction of rotation switch
left to slacken a screw or screw it out.
Switching between drilling /
Q
hammer-action
Note: The hammer-action drilling mode is intended
for drilling into brick, concrete and stone only.
Note: The drill / hammer-action switch
only be moved after the device has come to a
standstill.
Drilling:
S et the drill / hammer-action switch
right into the position.
Impact drilling:
S et the drill / hammer-action switch
left into the
.
6

Servicing and cleaning

Q
Switch the device off and pull the plug out of the
mains socket before carrying out any work on the
device.
D o not allow any liquids to enter the device.
Use a cloth to clean the device.
C lean the device after you have finished using it.
D o not under any circumstances use petrol or
strong solvents.
S tore the device in a dry room.
is pressed down.
6
7
7
4
4
4
position.
DANGER OF INJURY!
GB/MT
to the
to the
must
to the
to the
41