Change Test Mode - Adixen H2000 PLUS 5.0 Manual Del Usuario

Change Test Mode

Select the main menu Change Test Mode
as described on page 11.
1. Press Enter.
2. Select Analysis Mode by pressing En-
ter again, or select Detection Mode or
Combined Mode by pressing >.
Tip!
To change quickly from Detection
Mode to Analysis Mode or vice
versa, press the right-hand button
three times in succession.
Explanations
In Detection Mode, the signal is displayed in the form of a bar. The length of
the bar varies with the gas concentration.
In Analysis Mode the measured value is displayed in figures, (see page 28). The
default unit is in PPM but it is possible to choose other units, see page 19.
In Combined Mode you can see the signal displayed as a bar and the measured
value in figures at the same time.
Esc
Esc
Adixen Scandinavia - User's manual H2000 PLUS
Change Test Mode
< > Enter
1
Change Test Mode
Analysis Mode
< > Enter
2
Analysis Mode
0.5
PPM
– Volume + Menu
GB
1