Hoover HMF250X Manual De Instrucciones página 3

B. Prepare the Cabinet.
1
1. Read the instruction on the BOTTOM CABINET TEMPLATE, put the
template on the bottom plane of cabinet.
2
2. Make marks on the bottom plane of cabinet according to marks "a" of the
template.
GB
BOTTOM CABINET TEMPLATE
NOTE: IT IS VERY IMPORTANT TO READ AND FOLLOW THE
DIRECTIONS IN THE INSTALLATION INSTRUCTIONS
BEFORE INSTALLATION.
This template is used to locate the cabinet bottom bracket holes
"a".
1. Check if your cabinet has a smooth, flat bottom and right size, and tape the
template onto the bottom plane of cabinet.
-Make sure the CENTER LINE of the template is in the middle of the cabinet
-Make sure the FRONT EDGE of the template is even with the cabinet front
edge
2. Make marks on the bottom plane of cabinet according to the hole "a" of the
template.
-Do not drill holes in the bottom cabinet.
3. After make all marks (10 marks) according to the instruction, remove the
bottom cabinet template.
4. After marking holes "a", continue to install according to the installation
instructions.
FRONT EDGE
2
CENTER LINE
FRONT EDGE
FRONT EDGE