Publicidad
Idiomas disponibles
Idiomas disponibles
Installation and safety
● The equipment described is designed solely for the installation of satel-
lite receiver systems.
● Any other use or failure to comply with these instructions will void the
warranty or guarantee.
● The equipment may only be installed in dry areas i
on or against highly combustible materials.
● The equipment must be provided with an earthing wire (Cu, at
4 mm
● The safety regulations set out in the current EN 60728-11 and EN 60065
standar
● Fixings: Screws, max. Ø: 4 mm
● Connectors: RF connector 75 Ω (series F) acco
● Unused RF ports must be terminated with 75 Ω resistors (e.g. EMK 03).
● An inner cable conductor
diameter greater than
1.2 mm, or the presence
of burrs may damage the
sockets on the unit.
Current-carrying device
● Do not open the unit or tamper with it!
● When working on the system always unplug the power supply unit from
the wall socket!
● The device is intended only for wall mounting! Do not install the device
lying flat or on its top, or operate it in th
● Ensure adequate clearance! Clearance all round at lea
● Free circulation of air must be possible to discharge the heat emitted by
the u
● Ambient temperature range -20 to +55 °C
Caution:
● No liquid-filled items may be placed on top of the power supply unit.
● T
w
● The mains plug must be easily accessible and operable.
● The only reliabl
unplug it.
2
).
ds
must be complied with.
ni
t. Danger of overheating!
he power supply unit must not be exposed to dripping or splashing
at
er.
e
method of disconnecting the unit from the mains is to
Max. 2 mm
excess
length
Tightening
torque 3.4 Nm
(danger of over-
winding)
is
position.
3 / 8
nd
oors. Do not install
le
ast
rdi
ng to EN 61169-24.
Diameter 0.6-1.2 mm
free of burrs
st
5 cm!
Publicidad
