Basic Operation - Johnson Health Tech Matrix C50 Manual Del Usuario

BASIC OPERATION

FREE AREA
0.6 (2
m ft
1
2
8
LOCATION OF THE EQUIPMENT
Place the ClimbMill on a level surface. For ease of access,
there should be an accessible space preferentially on both
sides and the rear of the ClimbMill that is at least 0.6 meters
(24 inches). Do not place the ClimbMill in any area that will
block any vent or air openings. The ClimbMill should not be
located in a garage, covered patio, near water or outdoors.
HEIGHT AND WEIGHT REQUIREMENTS
The equipment adds 20" – 25" (50 – 64.5 cm) to a user's height. For
example, a 6'1" (185 cm) tall user will be 7'9" – 8'2" (236 – 249 cm)
off the floor. The C50 requires a minimum user weight of 99 lbs
)
(45 kgs) and has a maximum user capacity of 300 lbs (136 kgs).
FOOTPRINT:
HEIGHT:
190 cm / 75"
WEIGHT:
138.5 kg / 293 lbs.
MOVING THE EQUIPMENT
The ClimbMill has a pair of transport wheels built into the
front of the frame. To move, first remove the power supply
and firmly grasp the console mast, carefully tilt (1) and roll (2).
Note: be sure to grab the steel bar and not the console.
WARNING!
Our equipment is heavy, use care and additional help if necessary when
moving. Failure to follow these instructions could result in injury.
135 x 72 cm / 53" x 28"
LEVELERS
LEVELING THE EQUIPMENT
It is extremely important that the levelers
are correctly adjusted for proper operation.
Turn leveling foot clockwise to lower and
counter-clockwise to raise unit. Adjust
each side as needed until the equipment
is level. Use of a level is recommended.