Flex FX1151 Manual Del Operador página 15

LED LIGHT (FIG. 13)
Fig. 13
Your tool is equipped with an LED light, located
LED Worklight
on the base of the tool. This provides additional
light on the surface of the work piece for
operation in lower-light areas.
The LED light will automatically turn on with a
slight squeeze on the variable-speed trigger
switch before the tool starts running, and will
turn off approximately 10 seconds after the
variable-speed trigger switch is released.
The LED light will rapidly flash when the tool
and/or battery pack becomes overloaded or too
hot, and the internal sensors will turn the tool
off. Rest the tool for a while or place the tool
and battery pack separately under air flow to
cool them.
The LED light will flash more slowly to indicate
that the battery is at low-battery capacity. Rech-
arge the battery pack.
-15-