Flex FX1351 Manual Del Operador página 12

LED LIGHT (FIG. 8)
Your tool is equipped with the LED work light.
This provides additional light on the surface of
the work piece for operation in lower-light areas.
The LED work light will automatically turn on
with a slight squeeze on the trigger switch
before the tool starts running. It will turn off
approximately 10 seconds after the trigger
switch is released.
a. The LED light will rapidly flash when the tool
and/or battery pack becomes overloaded or
too hot, and the internal sensors will turn the
tool off. Rest the tool for a while or place the
tool and battery pack separately under air flow
to cool them.
b. The LED light will flash more slowly to indicate
that the battery pack charge is at low capacity.
Recharge the battery pack.
c. If the LED does not turn on when you start the
tool, or it turns off suddenly during operation,
please contact customer service or an
authorized service center for assistance.
Fig. 8
-12-