Flex FT161 Manual Del Operador página 9

WARNING
drywall screwdriver prior to performing
maintenance or cleaning.
SERVICE
WARNING
personnel may result in misplacing of internal
wires and components which could cause a
serious hazard. We recommend that all tool
service be performed by a FLEX Factory Service
Center or Authorized FLEX Service Station.
GENERAL MAINTENANCE
WARNING
parts. Use of any other parts could create a
hazard or cause product damage. Periodically
To remove dust and debris from the interior of
the magazine, follow the steps below:
REMOVING AND INSTALLING THE
ADVANCING MECHANISM
The advancing mechanism
CAUTION
is spring loaded. Always
use both hands to remove the advancing
mechanism. The return spring may eject from
the mechanism.
TO REMOVE THE ADVANCING MECHANISM
(FIG. 10a & 10b)
a. Disconnect the magazine from the
screwdriver.
b. Depress and hold the large spring pin.
c. Turn over the magazine and depress and hold
the small spring pin.
d. Pull the advancing mechanism off the
magazine
MAINTENANCE
Disconnect the collated
screw magazine from the
Preventive maintenance
performed by unauthorized
When servicing, use only
identical replacement
inspect the entire product for damaged, missing,
or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or
damaged parts are replaced. Please contact
customer service or an authorized service
center for assistance.
Use a brush and blow dust and debris out of the
main housing with dry compressed air as needed.
WARNING
when using compressed air.
WARNING
cleaning the non-metallic parts of the
magazine. These chemicals may weaken the
materials used in these parts.
Fig. 10a
Fig. 10b
c
Small Spring Pin
-9-
CLEANING
Wear appropriate eye
protection and dust mask
Never use solvents or
other harsh chemicals for
b
Large Spring Pin
d