Using Attachments - Flex FX4111 Manual Del Operador

WARNING
performing any assembly, adjustments, or
changing accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
Your tool is shipped with the attachment collar
that accepts the depth gauge or the edge
guide. To install the attachment collar, follow
instructions in the chapter "INSTALLING AND
REMOVING THE ATTACHMENT COLLAR"
earlier in this manual.
DEPTH GAUGE (FIG. 13)
The depth gauge allows you to control the depth
of the plunge cuts. This is especially helpful
when plunge cutting an opening in drywall
where you don't want to accidentally damage
objects or surfaces behind the drywall.
To use the depth gauge:
a. Insert it into the attachment collar and set the
distance "X" between the tip of the plunge
blade and the tip of the depth gauge.
b. If the blade is installed at an angle, loosen the
collar locking bolt and rotate the collar around
the neck of the tool until the depth gauge is
parallel to the blade. Tighten the collar locking
bolt.
c. The bent tip of the depth gauge can be
positioned either above the blade or to the
side based on your preference and situation.
d. Tighten the locking knob. This will be your
depth of cut.

USING ATTACHMENTS

Detach the battery pack
from the tool before
Fig. 13
Depth
Gauge
Locking
Knob
-18-
X
Collar
Collar
Locking
Bolt