Additional Safety Rules - Weidmuller DMS PRO 1479120000 Manual De Instrucciones

Original instructions: English
Translation of the original instructions:
Other languages
Read the Safety Instructions booklet and
the following before using.
I. ADDITIONAL
SAFETY RULES
1) Wear ear protectors when using
the tool for extended periods. Pro-
longed exposure to high intensity
noise can cause hearing loss.
1) Be aware that this tool is always in
an operating condition, since it does
not have to be plugged into an elec-
trical outlet.
2) When drilling into walls, floors, etc.,
"live" electrical wires may be encoun-
tered. DO NOT TOUCH THE CHUCK
Or ANY FrONT MeTAL PArTS OF
THE TOOL! Hold the tool only by the
plastic handle to prevent electric shock
in case you drill into a "live" wire.
3) If the bit becomes jammed, immedi-
ately turn the main switch off to pre-
vent an overload which can damage
the battery pack or motor. Use re-
verse motion to loosen jammed bits.
4) During charging, the charger may
become slightly warm. This is nor-
mal. Do not leave the battery in the
charger for more than 24 hours after
charging is completed.
Symbol
V
n
0
Revolutions or reciprocations
... min-
1
Electrical capacity of battery
Ah
To reduce the risk of injury,
user must read and under-
Meaning
Volts
Direct current
No load speed
per minutes
pack
Rotation only
stand instruction manual.
WARNING:
• Do not use other than the Weidmüller
battery packs that are designed for use with
this rechargeable tool.
• Weidmüller is not responsible for any
damage or accident caused by the use
of the recycled battery pack and the
counterfeit battery pack.
• Do not dispose of the battery pack in a fire,
or expose it to excessive heat.
• Do not drive the likes of nails into the
battery pack, subject it to shocks, dismantle
it, or attempt to modify it.
• Do not allow metal objects to touch the
battery pack terminals.
• Do not carry or store the battery pack
in the same container as nails or similar
metal objects.
• Do not charge the battery pack in a high-
temperature location, such as next to a fire
or in direct sunlight. Otherwise, the battery
may overheat, catch fire, or explode.
• Never use other than the dedicated charger
to charge the battery pack. Otherwise, the
battery may leak, overheat, or explode.
• When the Battery Pack Has Deteriorated,
Replace It with a New One.
• Continued use of a damaged battery pack
may result in heat generation, ignition or
battery rupture.
II. ASSEMBLY
& OPERATION
•
Hexagonal Bit Chuck
Attaching the bits
NOTE:
When attaching or removing drill bits,
disconnect the battery pack from the
tool and switch the lock button into the
lock position.
1. Hold the collar of the chuck and pull it out
from the driver.
2. Insert the bit into the chuck. Release
the collar.
-6 -
For indoor use only.