Hoover Dynamic NEXT Manual Del Usuario página 4

● WARNING Do not use the product if the fluff filter is not in position or is
damaged; fluff could be ignited.
● WARNING Where the hot surface symbol
temperature rise during operation of the tumble dryer may be in excess of
60 degrees C.
● Remove the plug from the electricity supply. Always remove the plug
before cleaning the appliance.
● Do not continue to use this machine if it appears to be faulty.
● Lint and fluff must not be allowed to collect on the floor around the
outside of the machine.
● The final part of a tumble dryer cycle occurs without heat (cool down
cycle) to ensure that the items are left at a temperature that ensures that
the items will not be damaged.
●The tumble dryer is not to be used if industrial chemicals have been used
for cleaning.
● WARNING: Never stop a tumble dryer before the end of the drying cycle
unless all items are quickly removed and spread out so that the heat is
dissipated.
●Maximum load drying weight : see energy label.
Installation
• Do not use adapters, multiple connectors and/or extensions.
• Never install the dryer against curtains and be sure to prevent items from
falling or collecting behind the dryer.
•The appliance must not be installed behind a lockable door, a sliding door
or a door with a hinge on the opposite side to that of the tumble dryer.
Important: During transport ensure that the dryer is in an upright position, if it's necessary you
can only flip in the side shown;
Caution: If the product is in different side, wait at least 4 hours before switching on so that the oil
can flow back into the compressor. Failure to do this could result in damage to the compressor.
0 4 EN
is located the