Rotary ARO14 Instrucciones De Instalación página 18

Note: All bolts and nuts mentioned in this booklet are grade
5 unless otherwise stated.
Note: Cotter pins are usually good for one time use only.
Replace any cotter pin, if removed, with a new cotter pin.
23. Rolling Jack:
A. Adjust rolling jack telescoping ends until roller rests
on runway track, Fig. 31. Make sure wheels are on
tracks and center rolling jack between runway on end
sections.
Adjustment Nut
Square
End
Rear Rolling
APPROACH
Jack Tubing
Jam Nut
Rear Column
Fig. 30
Air Inlet
Assembly
B. Place jack on runway track at front and rear with air
pump facing ends of runways.
C. Recommended operating pressure is 100-120 PSI.
D. Attach rubber stops see Fig. 31.
Runway
Runway
Track
Attach rubber bridge stops to 9.5mm holes 14" off center
of runways. Insert M6-35 bolt up through runway and
stop. Attach M6 and Ø6mm flat washer to top of stop.
Recoil Hose
Hose Bracket
Hose
Bracket
Rear Rolling Jack
Swing Air Jack - Optional
Front Rolling Jack
Swing Air Jack - Optional
18
Rolling
Jack
Runway
Telescoping
End Sections
Flange Nut
Rubber Stop
Track
Bolt Holding
Rubber Stop
Fig. 31
Quick Disconnect
Coupler
Front Rolling Jack
Tubing Assembly
Fig. 32