Publicidad
Idiomas disponibles
Idiomas disponibles
KIT AUTO
INSTALLATION, USE AND MAINTENANCE MANUAL
Dear Customer, congratulations on choosing this Made in Italy ATLAS FILTRI product.
Please carefully read and keep this document that will help you best enjoy and use all our products. Continue to prefer us
and beware of imitations.
KIT AUTO is suitable to the HYDRA self cleaning filters series and to the filters series with discharge system PLUS S 3P BX
and CX, DP S and DP S DS, K PLUS S 3P and K DP S.
SOLENOID VALVE CONNECTIONS
- Screw in the nipple with O-ring on the
bottom of the cup.
- Screw in the solenoid valve, being
careful that the flow direction arrow
faces down.
- Screw the drain funnel or hose fitting
onto the solenoid valve.
- Connect the programmer connector
to the specific solenoid valve housing.
At the start the timer shows "rEl"
followed by the version number (100),
then the timer goes into "Working
Mode" indicated by the flowing lines in
a circle on the display.
1 Programming
mode
interval between two successive
washes(in hours):
From "Working Mode" press the
button SET, the display shows the
symbol H followed by a number that
indicates the interval between two
washes. Then press the MANUAL
button to modify the number using
the SET button to decrease and the
MANUAL button to increase the
interval from a minimum of 2 hours
and a maximum of 99 hours. To
confirm the currently selected
interval do not touch any button for
at least 3 seconds.
To come back into "Working Mode"
do not touch any button for at least
10 seconds.
Manufacturer's identification: ATLAS FILTRI s.r.l.
Headquarter: via Pierobon, 32 | Production site: via del Santo, 227
I-35010 Limena, Italy - Tel. +39.049.76.90.55 Fax +39.049.76.99.94
www.atlasfiltri.com
of
the
GB
Publicidad
