Signature UPSE3024ST Manual Del Usaurio página 12

Test Run
Check if the range is properly installed and run a test
cycle.
1
Turn the oven mode knob to the Off position to
start test.
2
Turn each knob to the Hi position to check
that the surface heating elements are working
properly. The elements should glow red and
radiate heat, and they should cycle on and off
periodically even when the knob is in the Hi
position. This cycling prevents the glass-ceramic
from being cracked by thermal shock.
IMPORTANT : The Warming Zone does not
consume enough power to glow red.
3
After checking all the surface heating elements,
check the locking system by pressing Probe
for three seconds. The oven door should lock
and the cooktop should not operate while the
Lockout function is turned on. Pressing Probe
for three seconds to disable Lockout.
4
Now check the oven's operation. Turn the oven
mode knob to select the Bake mode. 350 °F
appears in the display. Press Start.
5
The oven should finish preheating in 15 minutes,
and the convection fan should operate while the
oven is preheating.
6
After checking the oven's operation, turn the
temperature up to 450 °F and leave the oven on
for at least an hour to help remove any oil which
might cause smoke and odors when first using
the oven.
NOTE
Smoke may come out of the range when it is first
used.
INSTALLATION 12