Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Preparation
Remove and recycle packing materials. Do not remove the
waveguide cover located on the upper surface of the drawer
interior. Refer to the illustration below.
Install an anti-tip block against the rear cabinet wall. Verify
screws are adequately secured and do not penetrate elec-
trical wiring or plumbing.
Installation
Turn power off to the electrical outlet.
1
Move the unit near the opening. Plug the power cord into
2
the grounded outlet.
Position the microwave oven in the opening and slide
3
back until the mounting flange is flush with the face of
the cabinet. Avoid pinching the power cord between the
unit and cabinet wall.
Open the drawer. Using the two holes on either side of
4
the mounting flange as a template, drill pilot holes into
the cabinet using a
1
/
" drill bit.
16
Mount the microwave oven using four screws provided.
5
Refer to the illustration below.
Turn power back on to the electrical outlet.
6
WAVEGUIDE
COVER
Waveguide cover.
Wolf, Wolf & Design, Wolf Gourmet, W & Design and the color red as applied to knobs are registered trademarks and service marks of Wolf Appliance, Inc. Sub-Zero,
Sub-Zero & Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, and Ingredients are registered trademarks and service marks
of Sub-Zero, Inc. All other trademarks or registered trademarks are property of their respective owners in the United States and other countries.
MOUNTING
FLANGE
Mounting.
Troubleshooting
IMPORTANT NOTE:
If the drawer microwave oven does not
operate properly, follow these troubleshooting steps:
•
Verify electrical power is supplied to the microwave
oven.
•
Verify proper electrical connections.
•
If the microwave oven does not operate properly, contact
Wolf factory certified service. Do not attempt to repair
the oven. Wolf is not responsible for service required to
correct a faulty installation.
|
wolfappliance.com
7
Publicidad
