Ibiza Pro DJM10:4USB-REC Manual De Instrucciones página 7

34) Headphone Level Control
Sets desired level to headphones. Headphone program depends on the position of
the monitor pan control and Cue switches.
35) Headphone Socket (Standard Stereo ¼" Jack)
L/H Channel:
R/H Channel:
Ground:
Minimum Load Impedance:
36) Power Switch
Controls the AC power to the mixer.
Note. Be sure to switch on the power to your mixer before switching on the amplification system.
37) AC Supply Socket
Supplied with an IEC lead. If the moulded plug is incorrect for your wall socket, it is
possible with caution to fit an alternative plug.
Cable colour code:
WARNING: THIS MIXER MUST BE EARTHED
38) Fuse Holder
This holder carries the 20mm fuse that is provided for safety.
Inspect and change the fuse if necessary with the correct type. If the unit fails to
operate when correctly connected to the AC supply, follow the instructions on the
rear of the mixer.
Note: ALWAYS disconnect the AC power cord before changing the fuse.
39) Ground screw
Grounding terminal for auxiliary equipment eg: Turntables
40) Channels 1 and 2 ¼" Jack unbalanced Mic inputs.
Use the selector switch, to switch from CD to Mic input.
41) 12V Light Socket
Suitable for a gooseneck lamp with maximum 5W lamp output.
42) MP3 Player
This mode allows to load and record MP3s from the USB stick.
42) +48V Phantom Power
When the Phantom Power is on, Mic 1 and 2 sockets can be connected to a
condenser microphone.
Electric products must not be put into household waste. Please bring them
to a recycling centre. Ask your local authorities or your dealer about the way
to proceed.
©Copyright Lotronic 2011
Tip
Ring
Sleeve
32 Ω
Live:
Neutral:
Earth:
Brown
Blue
Yellow/Green
Page 7