Tool-Specifi C Safety Information; General Safety Information - Rehau RAUTOOL G1 125 Manual De Instrucciones

RAUTOOL G1 125/160
SAFETY INFORMATION
Use in line with provisions
The tool is intended exclusively for processing of the REHAU
compression sleeve system in the size range 125 x 12.6 or
160 x 14.6.
Note:
Read all safety information and assembly instructions before the initial
operation of the tool. Observe the information during operation and
always keep the safety information with the tool.
In addition to the operating instructions, generally valid, legal and
other binding regulations on accident prevention and protection must
be observed and passed on.

General safety information:

1. Keep your workplace tidy and free of obstructions. Make sure
there is always suffi cient light.
2. Keep children, pets and unauthorised persons away from your
workplace. Do not let other people touch the hydraulic hose, the
tool or the cables.
3. Wear suitable work clothing. Do not wear loosely fi tting clothes or
jewellery. They may get caught in moving parts. Wear a hairnet if
you have long hair. Use protective goggles!
4. Do not touch moving parts (risk of trapping fi ngers)!
5. Be aware. Only use the equipment if you have been instructed in
how to handle it.
6. Keep your tools in a safe place. When not in use, tools should be
kept in dry, locked rooms out of the reach of children.
7. The tool is only suitable for manufacturing REHAU compression
sleeve joints of the sizes 125/160 mm. Do not use the tool or the
electro-hydraulic unit for other purposes or sizes.
8. Only operate the equipment with REHAU original parts and acces-
sories.
9. Only allow maintenance and repair work to be carried out in a
specialised workshop authorised by REHAU. For work by external
personnel, we do not assume any liability. The addresses of the
authorised service centre can be obtained from your dealer or
REHAU Sales Offi ce.
Tool-specifi c safety information:
1. Protect the tool from moisture, extreme heat, oil and solvents.
2. Do not carry your hydraulic unit by the supply lead or hydraulic
hose. Do not pull the equipment by the cable or hydraulic hose.
3. Make sure that the hydraulic hose and the supply lead are not da-
maged. Before initial operation, check the hydraulic hose and the
supply lead for example for scuff marks, cuts, cracks, squashed
points, kinking, etc. Never work with a damaged hydraulic hose or
supply lead. Get damaged hydraulic hoses or supply leads replaced
immediately at the REHAU service centre.
4. Do not touch any possible leaks in hydraulic hoses while the
system is pressurised.
5. Do not try to disconnect the quick couplings while the system is
pressurised.
6. In a disconnected state, the quick coupling must not be pressuri-
sed.
7. The hydraulic hose must be replaced for safety reasons (legal
regulations) after 5 years at the latest by an authorised REHAU
service centre. Make sure you observe this timeframe. The year of
construction of the tool can be found on the warranty certifi cate.
If anything is unclear, please contact your dealer or REHAU Sales
Offi ce.
8. Do not connect the pump/motor unit to any other cylinders or tools.
19