Setup And Operation; Battery Installation - DeVilbiss Healthcare DV6EB Manual Del Usuario

SETUP AND OPERATION

Battery Installation

If you ordered a second optional battery pack or the unit was delivered without the
battery pack installed, follow these steps to install:
1. Placethechargingbaseonaflat,clean,drysurface.
2. Remove access cover screw using Phillips screwdriver, then remove access cover.
Access Cover
Screw
Access
Cover
3. Insert a DeVilbiss battery pack (part number DV6EB-613) into either left or right
charger slot opening. Orient battery with battery connection terminals facing the
opening and toward the top. Insert optional second battery pack in same manner if
purchased separately.
4. Replace access cover and secure with screw. Tighten securely but do not
over-tighten.
Setup and Initial Charge
TheExternalBatteryneedstobefullychargedbeforefirstuse.ExternalBatterywill
charge within 5 hours from fully discharged state with 2 battery packs installed. It will
charge faster with only 1 battery pack installed. Follow these steps to charge your
External Battery:
1. Ensure that the External Battery is properly connected to the provided 120 Watt
power supply and to an AC power source with adequate voltage (100-240VAC) using
the AC power cord that came with your CPAP. The Charging Status LED and
External Power indicator will illuminate when connected to an external power source.
A-DV6EB-1
2. Secure the power cord from the power supply into the Power Cord Retention Clip. To
secure the cord, place the cord through the clip and press the clip until it latches.
Press the clip release to unlatch if disconnecting the cord.
Shown with
Optional second
Battery Pack
3. To check charge status: Press the center Check Status button to activate Battery
Fuel Gauges. LEDs will illuminate for four seconds then go out.
NOTE – External Battery can remain plugged in at all times if desired.
NOTE – Charge time may increase if using the CPAP while charging the external
battery.
NOTE – External battery is for use with AC power only. It cannot be charged/used with
DC power.
NOTE – Higher pressure and heater settings may require 2 battery packs to be installed
in the charger base for longer use time. Refer to the Battery Run Time Charts for details.
Shown with Optional
second Battery Pack
EN - 5