Non-rechargeable batteries are
not to be recharged. The supply
terminals are not to be short-cir-
cuited.
Do not mix new and used batteries
or different battery types.
Rechargeable batteries are to be
removed from the appliance before
being charged.
Insert batteries with correct
polarity.
Replacing the batteries
Make sure the appliance is turned
off.
To open the battery cover (6), turn
it 90° as shown in (c). Insert batter-
ies with the poles in the direction
marked. Close the battery cover.
Shaving
Turn the twisting protective cap (4)
(a) until it clicks into place as
shown (b). To switch the shaver
on, slide the on/off switch (3) up.
Long hair trimmer
(M-90 model only)
Use the extendable long hair trim-
mer (5) for exact trimming of side
burns and moustaches. To oper-
ate, slide the long hair trimmer to
the right (e) and turn on the appli-
ance. After use, slide it back until it
engages.
Cleaning and maintenance
For optimum shaving performance,
clean the appliance after each use.
Cleaning under running water
Turn on the appliance. Rinse the
shaver head under hot running wa-
ter until all residues have been re-
moved (f). You may also use liquid
soap without abrasive substances.
Rinse off all foam and let the shaver
run for a few more seconds. Then
turn it off, remove the shaver foil (1)
as shown (g) and let it dry. If you of-
ten clean your appliance under run-
ning water, put a drop of light ma-
chine oil onto the shaver foil.
Cleaning with the brush
Remove the shaver foil (1) and tap
it gently against a flat surface.
Then thoroughly clean the cutter
block (2) with the brush (7) as
4