NUGENI VAC+ VAP010 Manual De Usuario página 13

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Power Up
Normal Power
1. Press power button to turn unit on.
> normal mode: solid green light
Turbo Power
2. Press power button again to activate
Turbo Mode for enhanced suction power.
> turbo mode: solid blue light
3. Press power button again to turn unit off.
Note: Motorized beater bar runs
in both normal and turbo mode.
Motorized Beater Bar:
Note: Beater bar can be removed for cleaning.
When necessary, follow these instructions:
Turn power off. Do not try to access
!
WA R N I N G
beater bar while vacuum is running.
Removal
1. Slide access door release
lever sideways.
2. Lift access door open.
3. Flip up locking clip on end
of beater bar.
4. Grasp clip and pull firmly
upward in diagonal
direction to remove beater
bar
Replacement
5. Insert fixed end of beater
bar at downward angle,
ensuring proper alignment
of drive sprocket tabs.
6. Press other side of beater
bar down until fully seated
into opening
7. Flip locking clip down and
press to "snap" secure
8. Close access door and
press to "click" secure
Cleaning
Regularly inspect beater bar for blockages: including hair, fibers, and large debris
Maintaining a clean beater bar greatly improves upright vacuum performance.
Use scissors or sharp knife to cut through tangled hair and fibers once beater bar is removed.
1-866-677-4420
Typical Run Times:
U P R I G H T
20
Normal Mode:
16
Turbo Mode:
1
3
4
7
6
5
min.
min.
Note: Upright vacuum and
beater bar are not designed
for use on rugs/carpets
with long fibers or extra
plush pile.
Note: Beater bar will turn
off automatically when
jammed. If this happens,
2
turn vac off, clear jam, then
restart vac.
Note: Ensure beater bar is
installed properly before
use to avoid damage to unit
and compromised cleaning
efficiency.
13

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Vac+ vap010wVac+ vap010ct

Tabla de contenido