Overload Indicator; Maintenance And Cleaning - Fagor BB-165 Manual De Instrucciones

6. OVERLOAD INDICATOR

If the scales are overloaded (more than 150
Kg / 330 lb), the screen will display an error
message: "Err"
7. RE-TEST
When the screen shows the letter "C",
this means that there has been an error
in reading your weight. Please get off the
scales and wait for them to switch off or
for the reading to go to 0,0. When this
happens, you can begin the weighing
process again.
8. BATTERY LOW INDICATOR
When the battery needs to be replaced, the
screen will show the following indication:
Open the cover on the back of the scales
and carefully take the battery out of its
compartment. Do not bend the contacts
when doing this or they will break. Remove
the battery and insert a new one. Put it on
the contact and then press down.
Remember that batteries are not
domestic waste. Used batteries
must be disposed of in containers
provided especially for that
purpose.

9. MAINTENANCE AND CLEANING

• The scales may be slippery if wet.
Make sure they are dry before using
them.
• Clean the scales with a dry cloth, and
prevent any water from getting inside.
Do not use strong chemical cleaning
agents like alcohol or benzene.
• Keep the scales in a cold place with dry
air instead of a damp or warm place.
• Keep the scales in a horizontal position,
instead of leaving them in a vertical
position, as the batteries can discharge.
• Do not try and open them to make
any repairs. This will invalidate your
warranty.
• Do not drop the scales or jump on
them when you are using them. Avoid
any sharp blows or shaking as the
scales are a precision appliance. Their
structure is delicate and sensitive to all
external impacts.
• If the scales do not work when you
switch them on, check that the battery
has been installed properly and has not
gone flat. Put it in properly or replace
and, if necessary, consult your supplier.
• If there is an error message on the
screen, let the scales switch off and
remove the battery for 3 seconds,
then put the battery back and turn
on the scales. If you cannot solve the
problem, contact your dealer for more
information.
10. INFORMATION FOR THE CORRECT
DISPOSAL OF ELECTRICAL AND
ELECTRONIC APPLIANCES
At the end of its working
life, the product must not
be disposed of as urban
waste. It must be taken to
a special local authority
differentiated waste
collection centre or to a
dealer providing this service. Disposing of
a household appliance separately avoids
possible negative consequences for the
environment and health deriving from
inappropriate disposal and enables the
constituent materials to be recovered to
obtain significant savings in energy and
resources.
To remind you that you must collaborate
with a selective collection scheme, the
8