Food Processing Attachments; Operation; Using The Cutting Blades - Silvercrest KM 250 C1 Instrucciones De Uso

Food processing attachments

1) Select the desired attachment:
–
the slicer attachment w
–
or the grater attachment q .
2) If a different disk is still installed: Ideally, turn
the disc adapter 0 upside down . Press the
long metal tab of the disc inwards with your
thumb so that this side of the disc is released
from the disc adapter 0 . You can now remove
the disc .
3) Insert the new disc with the short metal tab first
into the disc adapter 0:
4) Then carefully push the side with the long metal
tab into the disc adapter 0 . The best way to
do this is to press with both thumbs on the
outer edges of the attachment until it clicks
completely into place in the disc adapter 0 .
5) Place the disc adapter 0 with the attachment
fitted onto the drive shaft 6 . The flattened side
of the drive shaft 6 must correctly fit into the
take up of the disc adapter 0 . Otherwise the
disc adapter 0 cannot be properly attached .
■ 36 │ GB │ MT
6) Place the lid 3 onto the bowl 5 so that the
arrow ▼ on the lid 3 coincides with the
arrow and the opened lock symbol
on the bowl 5 .
7) Turn the lid 3 until the arrow ▼ on the lid 3
points to the arrow
symbol on the bowl 5 .
8) Place the pusher 1 into the feed tube 2 .
9) Insert the plug into a mains power socket .

Operation

Using the cutting blades

The cutting blades 4 can be used to chop foods
such as onions or meat .
NOTE
► Do not attempt to mix liquids with the cutting
blades 4 . These will overflow or spray out .
1) Fit the cutting blades 4 as described in the
chapter "Assembling the appliance" .
2) Cut the ingredients into pieces of
approximately 2 – 3 cm .
3) Pour the ingredients in . Do not exceed the
quantities specified in the following table .
INGREDIENT MAX . AMOUNT
Bread
Cheese
Meat
Herbs
Garlic
Onions
Ice cubes
and the closed lock
SPEED
max . 80 g ON
max . 150 g ON
max . 300 g ON
max . 30 g ON
80 – 200 g PULSE
max . 300 g PULSE
max . 140 g PULSE
KM 250 C1