Thermador HMWN30 Manual Del Usuario página 10

Fix Duct to transitionand seal withtape.
For both ins tallation method :
10. Wiring the HOOD:
WARNING:
To Avoid Electrical Shock Hazard
Turn off power at the service
panel before wiring this unit.
120 VAC, 15 or 20 Amp circuit
required.
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN
ELECTRICAL JUNCTION BOX WITH 3
WIRES, ONE OF WHICH (GREEN/YELLOW)
SERVES TO GROUND THE APPLIANCE.
WARNING:
TO PROTECT YOU AGAINST ELECTRIC SHOCK,
THE GREENAND YELLOW WIRE MUST BE
CONNECTED TO THE GROUNDING WIRE IN
YOURHOME ELECTRICAL SYSTEM, A ND IT MUST
UNDERNO CIRCUNSTANCES B ECUTORREMOVED .
Failure to do so can result in death or
electrical shock.
INTEGRAL VENTILATOR
INSTALLATION Models VTN600F & VTN1000F
The Integral ventilator can be mounted to
discharge air as show on figure 3 and 4b at page 9.
It must be fixed through the slots of the ventilator
and pins with nuts of the hood.
Tighten the two nuts.
Machine screws
Motor Bracket
Figure 5a
Millimetric nuts
Spring
Millimetric screws
The integral motor blowers should be installed to the
hood with the hardware provided (Machine screws,
millimetric screws, millimetric nuts, motor bracket and
spring) in the VTN600F and VTN1000F hardware bags.
Machine screws
Motor Bracket
Millimetric screws
Install these components as is shown in the
picture 5a for VTN600F and 5b for VTN1000F.
10
Millimetric nuts
Spring
Figure 5b