In Phase IPA 2001D Manual De Instrucciones página 9

OPERATION
L
R
LINE OUT LINE IN
1. RCA Input Jacks
4. Subsonic Filter
7. Remote Control Jack
CONTROL AND CROSSOVER
1. RCA Input Jacks- Low level-high impedance inputs.
U se high quality RCA cables designed for mobile applications.
2. Input Level Control- Adjust the input level for the marked channels.
T urn clockwise to increase the level, counterclockwise to decrease.
Amplifiers will run cooler and produce less system noise at lower level settings.
3. Low Pass Frequency- Adjust the crossover frequency by turning clockwise to set
to a higher f requency , counterclockwise to set to a lower frequency.
4 . Subsonic Filter Frequency- Adjust the subsonic filter frequency by turning clockwise
to set to a higher frequency, counterclockwise to set to a lower frequency.
5 . The Bass Boost control is used for a1-12dB Gain at 45Hz for extra bass punch.
6. Phase Control- Adjust the relative phase of the output a range of 0 to - 1 80 degrees
for solid bass r esponse and accurate imaging.
7. Remote Control Jack- For connecting the remote control module to the amplifier .
8. Master/Slave Switch- Select the remote level control or the on-board level control
as the master control.
9. Slave Input Jack- Used to connect to another amplifier when bridging 2 amps together .
T he Slave mode bypasses normal input jacks and controls.
L
MIN MAX 15Hz 50Hz 0dB 12dB 50Hz 250Hz 0
LEVEL SUBSONIC BASS L.P.F
BOOST
R
2. Input Level Control
5. Bass Boost Control
8. Master/Slave Switch
7
IN
180 MASTER SLAVE
PHASE
REMOTE
OUT
MASTER/SLAVE
3. Low Pass Frequency
6. Phase Control
9. Slave Input Jack