SPM FROSTY DREAM 2 Manual De Instrucciones página 24

Fig. 18
Fig. 18 bis
24
g) Mount the mixing unit back together, according to the
h) Mount the bowl (A) back on, positioning it into place,
i) Secure the bowl (A) by keeping it lifted until the bolt (S)
l) Rassemble the parts of the dispensing tap, making
Fig. 19
Warning: the not perfect sliding of the tap compromises its
own seal.
Fig. 20
following procedures (see figure 18):
- it's indispensable to spread the gaskets (O) with
vaseline grease to reduce friction and thus limit
wear.
- mount the washer (P) making sure it faces the right
direction (fig.18 bis);
- replace the scraper spiral (N), making sure the head
is perfectly engages with the driving shaft;
- secure all the parts into place by screwing the bolt
(M) in a counterclockwise direction.
and making sure that it has a tight hold on its washer
(see figure 19). To facilitate this procedure, we also
suggest that the rear part of the bowl be moistened at
the point in which it fits together with its sealing
washers.
is aligned with its hole (K), then tightly screw the two
knobs (P), without exerting excessive pressure, so as
not to risk cracking the threading fillets (see
figure 20).
sure that the gaskets (J) are covered with vaseline
grease so that the tap slides smoothly back into its
fixed position, until it's completely insered (see figure
21).