Safety Instructions For Grinding Rollers - Parkside PSR 310 A1 Instrucciones De Utilización Y De Seguridad

c) The rated speed of the attachment must
be at least the maximum speed speci-
fied on the power tool. Accessories turning
faster than the rating can break and fly about.
d) The outside diameter and thickness of
the attachment must correspond with
the specifications of the power tool. In-
correctly sized attachments cannot be properly
shielded or controlled.
e) Grinding discs, flanges, disc wheels or
other accessories must accurately fit
the grinding spindle on your power
tool. Attachments which do not accurately fit
the grinding spindle will rotate unevenly, vibrate
severely and can result in losing control.
f) Do not use damaged attachments. Be-
fore each use, check attachments such
as grinding discs for chips and tears,
disc wheels for tears, wear or severe
abrasion. If the power tool or the at-
tachment is dropped, check it for dam-
age or use an undamaged attachment.
After checking and installing the at-
tachment, you and persons nearby
should stay from the level of the rotat-
ing attachment, and allow the device
to run at maximum speed for a minute.
Damaged attachments typically break during
this test time.
g) Wear personal protective equipment.
Depending on the application, wear
full face protection, eye protection or
safety goggles. Where appropriate,
wear a dust mask, ear protection, pro-
tective gloves or a special apron to
deflect small grinding- and material
particles. Protect the eyes from foreign
objects flying about during various
applications. Dust- or respirator masks
must filter out the dust which arises
during use. Exposure to loud noise for extend-
ed periods can result in hearing loss.
h) Be sure other persons keep a safe dis-
tance to your work area. Anybody
entering the work area must wear per-
sonal protective equipment. Fragments
from the work piece or broken attachments can
General power tool safety warnings
fly about and cause injuries, including outside
the immediate work area.
Always hold the power tool by the in-
i)
sulated handle surfaces when perform-
ing work where the attachment may
strikes hidden electric cables or the
power cored. Contact with a live wire may
also charge metal parts of the device and re-
sult in electric shock.
Keep the mains cable away from ro-
j)
tating attachments. Losing control of the
device may result in the mains cable being cut or
caught, pulling your hand or arm into the rotat-
ing attachment.
k) Never put down the power tool until
the attachment has come to a complete
stop. The rotating attachment can come into
contact with the surface, resulting in a loss of
control over the power tool.
Do not run the power tool whilst car-
l)
rying it. Clothing may get caught in the rotat-
ing tool due to accidental contact and the tool
pierce your body.
m) Regularly clean the ventilation slots
on the power tool. The motor fan will suck
dust into the housing, and a high accumulation
of metal dust can result in electrical hazards.
n) Do not use the power tool near flam-
mable materials. Sparks could ignite these
materials.
o) Do not use attachments requiring liquid
coolant. Using water or other liquid coolants
can result in electric shock.
Safety instructions for
grinding rollers
Hold the device by the insulated handle
surfaces, as the sanding sleeve may
strike the tool's mains cable. Damaging
a live wire may charge metal parts of the de-
vice and result in electric shock.
RISK OF FIRE DUE TO SPARKS! Grinding
metals produces sparking. Thus be very careful
not to endanger persons, and that no flamma-
bles are near the work area.
GB 33