Publicidad
Idiomas disponibles
Idiomas disponibles
1. Make sure that the hard disks do not have any defective
sectors, as a hard disk with defective sectors can cause
unpredictable problems.
2. Insert the source hard disk into Bay A, then insert
the destination hard disk into Bay B. Make sure that
the hard disks are connected to the SATA connection
of each bay.
3. Connect the power supply from the power socket to
the Docking Station and press the power button to start
the device.
4. Wait at least 10 seconds until the system is ready.
5. Press and hold the clone button for 3 seconds to start
the process, the indicators in the LED bar will report the
status of the cloning:
• The LEDs start flashing sequentially.
• Green LED stops flashing: 25% cloning.
• Red LED stops flashing: 50% cloning.
• Yellow LED stops flashing: 75% cloning.
• Orange LED stops flashing: 100% completed cloning.
6. When the cloning process is completed, press the power
button to turn off the device. Remove the hard disks carefully
as they may reach a high temperature.
OTB Function
• Only available for Windows operating system computers.
• This action will be executed using the software included
on the CD that accompanies the product.
• Back up hard drives that are inserted into the Docking
Station.
EN
13
Publicidad
