Installation Of Storage Bracket; Installation Of Receiver - Emerson RCBT100 Manual De Uso

7. Installation of Storage Bracket

A storage bracket is provided for holding your
transmitter when not in use. If you desire to
use the storage bracket, install it on a wall
that is away from excess heat or humidity.
Use the two screws provided with storage
bracket.
WARNING
!
To avoid possible electrical shock, be
sure electricity is turned off at the
main fuse or circuit breaker box
before installing the receiver.
Note: Make all wiring connections using only
listed wire connectors (supplied). Make sure
all connections are tight, including ground,
and no bare wire is visible at the wire
connectors, except for the supply circuit
ground wire.
1. After electricity has been turned off at main
fuse box or circuit breaker box, remove the
ceiling cover from the hanger bracket.
2. Disconnect the supply wiring to the fan by
removing wire connectors.
Note: Do not disconnect the BARE/GREEN
GROUND wires.
3. Connect the supply BLACK wire to the
receiver RED wire (AC IN L).
4. Connect the supply WHITE wire to the
receiver WHITE wire (AC IN N).
AC SUPPLY
RECEIVER
BARE
Figure 5

8. Installation of Receiver

TO
WHITE
GREEN/GROUND
FAN HOUSING
Figure 4
5. Connect
(TO MOTOR N) to the fan WHITE wire.
6. Connect
(TO MOTOR L) to the fan BLACK wire.
7. Connect the receiver BLUE wire (FOR
LIGHT) to the fan BLUE wire and fan
YELLOW wire (if present).
Note: This wiring configuration will control
the up light and down light together.
A maximum of 300W total lighting can be
used with this receiver. Exceeding this
wattage will damage the receiver and void
the warranty.
CAUTION: If no light exists on your
ceiling fan, cap the BLUE wire on the
receiver with a wire connector.
8. Push the connected wires up into the
junction box and position the receiver in
the hanger bracket above the hanger ball.
Lay the antenna wire on top of the
receiver.
9. Reinstall the ceiling cover and restore
electrical power to the circuit.
ANTENNA
BLACK
YELLOW
BLUE
(if present)
CEILING
COVER
LIGHT
4
STORAGE BRACKET
STORAGE BRACKET
SCREWS (2)
(Figure 4)
(Figure 5)
the receiver
the receiver
RECEIVER
HANGER
BRACKET
HANGER
BALL
U.L. Model No: MR101F
WHITE wire
BLACK wire