Shutting Down; Machine Maintenance - Viper CEX410 Manual Del Usuario

water pump switch.
5) Use the lever on the hand tool to spray on
detergent solution
6) When cleaning is completed, turn off water
pump /vacuum motor switch and then
squeeze trigger 3 seconds to relieve water
pressure from solution lines.

Shutting down

1) Turn off machine, unplug and remove
power cable.
2) Empty the recovery tank and solution tank.
(refer to Draining tanks)
Draining tanks
Draining recovery tank (refer to F8):
1) Move the machine to an appropriate
draining location. (Please consider the
environment)
2) Hold the drain hose for the recovery tank
and lower it over the drain. Open the drain
hose cover for recovery tank draining.
3) Replace the drain hose back onto machine.
Draining solution tank (refer to F9):
1) Move the machine to an appropriate
draining location. (Please consider the
environment)
2) Disconnect the hose coupling and lower the
hose for solution tank draining.
3) Connect the hose coupling back onto the
machine.

Machine maintenance

Warning: To avoid the risk of electrical
shock please always confirm that the
machine is unplugged prior to performing any
maintenance or repairs.
To keep the machine performing well and
prolong its life time, please perform the
following maintenance procedures.
Daily maintenance
1) Drain and rinse the recovery tank and
solution tank.
2) Check quick couplers and nozzles. Clean if
required (Note: Never use a pointed object to
clean nozzles, only rinse them with hot water)
(refer to F10).
3) Remove float filter from the recovery tank
and clean it with water (refer to F11).
4) Check filling port filter and clean it with
water (refer to F12).
5) Check water pump filter below the machine
and clean it with water (refer to F13).
6) Check rolling brush and remove any debris
or carpet fibers.
Warning : Turn off the power switch
and disconnect the main plug before
checking the rolling brush.
7) Check vacuum shoe and remove any debris
or carpet fibers.
8) Clean machine with a soft after use.
9) Check power cable, extension cord and
hoses for damage before each use of the
machine.
Monthly maintenance
1) Check the rolling brush for any wear and
tear. Replace if necessary.
2) Check hoses and seals to see if there are
damages. Replace if necessary.
3) Check the machine for water leaks.
4) Lubricate wheels.
5) Check machine for loose or missing nuts,
screws , bolts and replace if necessary.
6) Check the V-belt for any wear and tear.
Replace if necessary.
Nozzle installation (refer to F14).
1. Nozzle base
2. Rubber seal ring
3. Spray tip nozzle
After the nozzle is cleaned, the nozzle needs
to be installed on the base. First, install the
rubber ring to the correct position, then press
down and rotate the nozzle for 90 degrees
aligning the nozzle in a horizontal direction,
the installation is complete.
Storage
Power cord storage
1) Bind the power cord by cable ties and store
on the power cord hook (refer to F15)
15
ENGLISH
.