Features; Charging The Internal Battery Of The Instant Power - Schumacher Electric INSTANT POWER IP-125 Manual Del Usuario

1

CHARGING THE INTERNAL BATTERY OF THE INSTANT POWER

IMPORTANT! CHARGE IMMEDIATELY
AFTER PURCHASE, AFTER EACH USE
AND EVERY 30 DAYS, TO KEEP THE
INSTANT POWER'S INTERNAL BATTERY
FULLY CHARGED AND PROLONG
BATTERY LIFE.
CHECKING THE LEVEL OF THE
INTERNAL BATTERY
Press the Battery Status button on the
front of the unit. The LED lights will indicate
the current charge level as follows:
RED – Indicates a 50% or less charge.
You should immediately recharge the
Instant Power.
YELLOW/ORANGE – Indicates a
50-75% charge.The Instant Power may
be used, but should be recharged as
soon as possible.
GREEN – Indicates the internal battery
is fully charged.
RED (CHARGING) – The Instant
Power is charging (connected to an
AC power source.) At full charge, the
CHARGED
CHARGING THE INTERNAL BATTERY
Charge the internal battery for the Instant
Power using an extension cord (not included).
NOTE: Use of an improper extension cord
could result in a risk of fire and electric shock.
1. To charge, plug an 18 gauge (AWG) or
larger extension cord into the charger plug
on the right side of the Instant Power.
2. Plug the extension cord into a 120VAC
electrical wall outlet.
3. The CHARGING
indicating charging.

FEATURES

2 3
(green) LED will light.
(red) LED will glow,
4
1. 12V DC Power Outlet
2. Charged/Charging LEDs
3. Battery Status LEDs
4. Battery Status Button
4. The CHARGED
light when the battery has reached full
charge. This could take up to 72 hours,
depending on the age and condition of
the battery. The charger will automatically
go into maintain mode and maintain the
battery at full charge, without damage.
5. Charge the Instant Power as soon as
possible after use.
CHARGING THE INTERNAL BATTERY
WHILE DRIVING
You may also charge the internal battery while
driving, using a male-to-male charger cable
(part number 94500109 – not included).
IMPORTANT: DO NOT CHARGE
INTERNAL BATTERY FOR MORE THAN
30 MINUTES OR LEAVE THE BATTERY
UNATTENDED. IT COULD EXPLODE,
CAUSING PROPERTY DAMAGE OR
PERSONAL INJURY.
1. Make sure the car is running.
2. Insert one end of the accessory cable into
the 12V DC power outlet.
3. Insert the other end of the accessory
cable into the vehicle's accessory outlet
(lighter socket).
NOTE: The RED LED does not operate
during this method of charging. Using this
method to charge the battery overrides the
maintain mode and the battery can be
overcharged.
4. Monitor the progress of the charge by
pressing the Battery Status button on
the front of the unit. When the battery is
fully charged, disconnect the accessory
cable from the Instant Power, then from
the lighter socket of the vehicle.
NOTE: Completely disconnect the charger
cable when the engine is not running.
5
• •
It
(green) LED will