EVERSPRING AC134 Guía De Usuario página 3

6. The following screen will appear. This means the gateway is entering binding mode.
7. At this point, insert the batteries into the AC134 and it will automatically bind with the
gateway.
8. The screen below will appear in 10 seconds if the process is successful.
Note: Time-out will occur if the binding process was unsuccessful. Please refer to the
"Manual Binding" in the Troubleshooting section.
IR Code Learning
The AC134 can now be programmed to learn the IR codes from the appliance's remote
control.
1. Plug the device to the AC mains using the DC
adaptor and power cable provided while still
leaving the batteries inside.
On the HomeSys main page, select "IR
2.
controller" icon at the top.
In the "DEVICES" tab, click the "+" under "IR Controller".
3.
4. Then select the appliance type to learn its remote control from.
In this example, selecting "TV" will create an icon in the "IRREMOTE" tab for the TV's
5.
remote control. Click on the edit icon as shown below.
6. This brings up a virtual remote control page with icon buttons representing the actual
buttons on the remote control. To start leaning the IR code, click on a button, for example
the Power On button.