First Time Use - Philips 5906131M7 Manual Del Usuario

First time use

1. After installation, turn on wall switch:
a. Only turn on the downlights you could like to perform grouping;
b. The downlight will be at default state, 2700K warm white and 100% brightness;
2. Within 20 seconds after turn on the wall switch, press and hold any of the group control
button (1,2,3,4), around 5 seconds later, the downlights will flash and means that those down
lights has been assigned to the corresponding selected group control button;
3. Short press the group control button, the corresponding assigned downlights will flash, now
you can control them (ON/OFF, light color and brightness);
4. Repeat step 1-2 if you want to assign another group of downlights;
5. In case of the downlights is not grouped properly, you can short press the last memory group
control button for 5 times, the assigned downlights will reset to default state, 2700K warm
white and 100% brightness. It means the grouping information has been cleared. Now you can
turn off the wall switch and repeat step 1-2 to assign the downlight again.
Specification
This remote controller is operated by 2xAAA battery. Battery lifetime
around 1 year.
operation distance: maximum 10 meters.
4