Product Description; Installation And Connection; Remedy Of Faults - Oase HeatUp Basis 10 W Instrucciones De Uso

- EN -

PRODUCT DESCRIPTION

Intended use
HeatUp Basis 10W/15W/20W, referred to in the
following as "unit", may only be used as specified
in the following:
•
As a substrate heater in an aquarium.
•
Operation under observance of the technical
data.
The following restrictions apply to the unit:
•
Only use indoors and for aquaristic purposes
in the home (not for commercial use).
•
Only operate with water at a water tempera-
ture of +4 °C to +35 °C.

INSTALLATION AND CONNECTION

How to proceed:
 B, C
•
Fit the suction cups into the clips by twisting.
•
Lay the heating cable in loops on the previ-
ously cleaned floor of the tank with the aid of

REMEDY OF FAULTS

Malfunction
Heating cable does not heat up.
10
the suction cups. Attach the suction cups
firmly to the glass.
– Ensure that no part of the cable overlaps
•
Cover the heating cable and suction cups with
sand, gravel or stones.
•
Route the heating cable out of the tank and
connect it to the supplied transformer.
– The part of the cable between the plug
•
Route the power connection cable such that
it forms a drip loop!
COMMISSIONING/START-UP
•
Switching on: Connect the unit to the mains.
The unit switches on immediately.
•
Switching off: Disconnect the unit from the
mains.
Cause
No mains voltage
Unit defective
or is kinked.
and the coloured indentation remains
cold.
Remedy
Check the mains voltage.
Replace unit
HeatUp Basis 10W/15W/20W