Switching On And Off; Remedy Of Faults - Oase LunAqua Power LED Driver Instrucciones De Uso

Establishing the connections
 E
Only connect spotlights of the product range LunAqua Power LED to this driver.
• Each spotlight can be connected to any free outlet of the driver directly or through the extension cable LunAqua Power
LED 10 m (42636).
• Observe the max. connected load. (→ Technical data)
– The connected load is calculated from the power consumption total of the individual spotlights connected to the
driver.
– For possible combinations of connectable spotlights, check the driver product site at www.oase-livingwater.com.
How to proceed:
 D
1. Remove the protection cap from the unit.
2. Fit the plug connector and secure with the two screws (max. 2.0 Nm).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.

Switching on and off

N O T E
Do not connect the driver to a dimmer. The device will be destroyed.
Switching on: Connect the power plug of the device to the mains socket.
• Check the function of the spotlights.
Switching off: Disconnect the device power plug.

Remedy of faults

Malfunction
Spotlight is not lit
Cleaning
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
If necessary, clean the unit with clear water using a soft brush.
• Ensure that no moisture can enter the unit.
Storage/overwintering
If the water or ambient temperature is outside the permissible temperature range, deinstall the unit and store it in a dry
place. (→ Technical data)
Cause
Spotlight not connected / no supply voltage
Driver defective
Spotlight defective
Remedy
Check all cables and connections.
Replace the driver.
Replace the spotlight.
- EN -
11