Wahl 7061 Manual De Instrucciones página 7

EN
MODELS WITH 2 LEDS
The red LED will flash for one second when turning off the shaver when it is time to
charge (below 10%).
The blue LED will light up while charging. LED will turn off when charging is complete.
MODELS WITH 5 LEDS
The LED meter will show the amount of charge left on the shaver.The fewer lights that
are lit, the lower the charge on the battery is.The red LED will flash for one second when
turning off the shaver when it is time to charge (below 10%).
While charging, the LED meter will show the progression of charging. All LEDs will turn off
when charging is complete.
SHAVING PROCEDURES FOR FAST, CLOSE SHAVES (A)
For maximum speed and efficiency, hold the shaver so that both screens are in contact
with the skin. When shaving the upper lip or neck, hold shaver so that the uppermost
screen is in contact with skin.
Shave both with and against the grain of the beard, and stretch the skin taut in the path
of the shaver. Guide the dual foil heads gently back and forth, primarily against the grain
of the beard. Do not press screen heads hard against face. Heavy scrubbing action with
the shaver could damage the foil and will not result in a closer shave.
Always replace the foil guard to protect the delicate dual foil heads when shaver is off.
SHAVING HEAVY BEARD GROWTH (B)
Begin shaving in a less dense area of the beard. Move the shaver in a circular motion on
a small area of the face (this picks up the hairs that grow in all directions). When you see
that this small area is shaved clean, gradually move into a new area while still using the
circular motion. Continue this motion, one small section at a time, until entire face is
shaved.
If your beard has more than 3 days of growth, use the pop-up Long-Hair Trimmer to cut
the beard down to about a one-day growth before using the shaver foil.
LONG-HAIR TRIMMER OPERATION (C)
Your shaver features a special long-hair trimmer located on the back of the shaver which
telescopes up from the foil head for precise and easy trimming of sideburns, beards or mustaches,
and for removing long hairs from the neck. And, as mentioned earlier, it can be used to "knock
down" heavy beard growth prior to shaving with the foil.
To use, remove Foil Guard and simply push the Long-Hair Trimmer Switch in an upward motion
until trimmer slides (clicks) into position. Push On/Off Switch. Then begin trimming/styling.
CLEANING AND MAINTENANCE (D)
SHAVER HEAD CARE
For maximum performance, we recommend you clean your shaver after every few shaves.
Any servicing, other than replacement of foil head and cutter bars, should be performed by an
authorized Wahl Shaver Service Center or Wahl Clipper Corporation (see Warranty for mailing
address information).
To clean, turn shaver "OFF" and remove the foil head by pushing the shaver head release buttons on
the sides of the shaver and lifting the foil head upward.
Lightly tap the open side of the foil head on a hard surface to remove the majority of loose stubble
particles. Be careful not to tap foil.
7
91590-400.indd 7 7/2/18 5:55 PM