Danby Designer DWC508BLS Guía Para Utilizar Y Cuidar Del Proprietario página 7

DOOR REVERSAL
INSTRUCTIONS
1) Unplug the unit from electrical outlet (if
connected) and lay it on its back.
2) Open the door until the screws securing the lower
door support bracket are exposed on the bottom of the
door (Fig. 2)
3) Remove the screw that is closest to the hinge
assembly and gently close the door to remove the
remaining screw from the support bracket.
4) Swing the door slightly towards the left side in
order to remove the support bracket from the door
and the lower hinge assembly.
5) Pull the door downward to remove it from the
cabinet of the wine cooler.
6) Remove the cap from the top left side of the door
(Fig. 4) and reinstall it on the top right side.
7) Remove the three (3) screws supporting the top
hinge (Fig. 1).
Door Plug
Plastic Caps (3)
Fig 3
OPERATING INTRUCTIONS (cont'd)
Fig 4
8) Remove the plastic caps from the left side of the
frame (Fig. 3) and reinstall them on the right side of
the frame (the previous hinge location).
9) Install the new left hand hinge assembly (supplied
with unit) on the left side of the frame.
10) Insert the lower door support into the left side
bottom hinge.
11) Carefully reposition the door firstly into the left
side upper hinge assembly, then onto the lower door
support bracket.
12) While the door remains closed, install the first
screw into the lower support bracket.
13) Open the door and install the screw that is closest
to the hinge assembly.
14) Close the door and return the unit to its upright
position (wait 60 mins before reconnecting power to
the wine cooler), verify the door allignment and
proper seal against the cabinet.
6
Upper Hinge Assembly
Fig 1
Lower Hinge Assembly
and Door Support Bracket
Fig 2