Velleman CCTVPROM16 Guía Rápida página 4

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
•
dealer will not accept responsibility for any ensuing defects or problems.
Do not use this product to violate privacy laws or perform other illegal activities.
•
4. Overview
Refer to the illustrations on page 2 of this manual.
Front panel
LED indications
NAVIGATE
MENU Press to enter the main menu.
ENTER Press to confirm settings
List the information of the recorded files.
LIST
QUICK SEARCH / RECORD / MOTION / ALARM / TIMER / FULL LIST
PLAY Press to play the recorded video.
SLOW In playback mode, press to play the recorded file slowly.
ZOOM In live or playback mode, press to enlarge the image of the selected channel.
SEQ Press to show all screens sequentially in full screen mode. Press again to quit.
4CH: Press to show the 4 channel display mode.
1 ~ 4 Press a button to select the corresponding channel.
SEARCH Enter time search mode. Set time range and press START to see all recordings within the time
range.
= SLOW + ZOOM
AUDIO
Press SLOW and ZOOM simultaneous to select live or play-back sounds.
= SLOW +
PTZ
(pan tilt zoom)
Press SLOW and
Connect a USB flash drive for video backup to one USB port; connect a USB mouse to the
USB port
other.
(2x)
Note: do not connect two USB flash drives or USB mice at the same time.
Rear panel
LAN port Connect the DVR to a local network by plugging a network cable into this port.
VGA connector for video monitor (monitor not included)
AUDIO IN 4 audio input channels to connect four external audio sources e.g. from cameras with audio.
AUDIO OUT 1 audio output to connect to an audio device, e.g. a speaker (mono).
VIDEO IN 4 video input channels to connect 4 external video sources e.g. cameras.
VIDEO OUT 1 video output channel to connect the DVR to the main monitor.
EXTERNAL I/O use a 9 pin DSUB connector to connect external signals, for example alarm, PTZ...
V. 02 – 21/08/2013
HDD reading or recording activities on the hard disk
ALARM an alarm was triggered
TIMER timed recording is enabled
PLAY the DVR is in playing mode
POWER DVR power is on
Press one of the four positions on the navigate button to move the cursor up
( ), down (
In play-back mode, press the buttons to play/pause (
rewind ( ) or fast forward (
In setting mode, press the up (
setting in the menu.
simultaneous to enter or exit PTZ control mode.
CCTVPROM16
), left ( ) or right (
) the play-back file.
) or down (
4
).
), stop (
) button to change the
©Velleman nv
), fast