Publicidad
ZY
x 3
FIG. 5
5) Attach Back Panel (I) to Back Vertical Support (L) with three #6 x 1" Oval Head Screws (ZY)
through the predrilled holes in back into back vertical support. Notch in back vertical support is to
be flush with bottom edge of back.
FIG. 6
6) Attach the Bottom Shelf (J) to the Left Side Assembly (G) by aligning the dowels (ZA) in the side
assembly with the dowel holes in the edge of the Bottom Shelf (J). The middle dowel holes in one
end of the Bottom Shelf (J) have been placed off center to ensure that the proper side of Bottom
Shelf (J) gets attached to the side assembly. See FIGURE 6.
ZF
x 3
FIG. 7
7) Attach Back Panel (I) with three 1/2" Cam Housings (ZF). See FIGURE 7.
Page 8 — 140W
TOP
Publicidad
