IROX JB913R Manual Del Usuario página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

P/N.: 086L001545-338 REV1
Page 8 of 44
TABLE STAND AND WALL MOUNTING
Table Stand:
Flip out the plastic stand on the rear of the thermo-Hygrometer for
table standing. Stand the Thermo-hygrometer on a flat surface.
Wall Mount:
Follow these steps to mount the Thermo-Hygrometer on a wall.
1. Drive a screw into the wall at the location you choose until the
head extends 3.5 mm from the wall.
2. Locate into the hanger slot on the back of the Thermo-
Hygrometer until it locks into place.
Note: For accurate measurement, you should mount the Thermo-
Hygrometer in an area where air can flow freely around it.
PRECAUTION
When handled properly, this unit is engineered to give you years
of satisfactory service. Here are a few product care instructions:
1. Do not immerse the unit in water. If the unit comes in contact
with water, dry it immediately with a soft lint-free cloth.
2. Do not clean the unit with alcohol containing detergent, abrasive
or corrosive materials. Abrasive cleaning agents may scratch
the plastic parts and corrode the electronic circuit.
3. Do not subject the unit to excessive: force, shock, dust,
temperature, or humidity. Such treatment may result in
malfunction, a shorter electronic life span, damaged batteries,
or distorted parts.
4. Do not tamper with the unit's internal components. Doing so
will terminate the unit's warranty and may cause damage. The
unit contains no user-serviceable parts.
5. Only use new batteries as specified in this instruction manual.
Do not mix new and old batteries as the old batteries may leak.
6. Read this instruction manual thoroughly before operating the
unit.
SPECIFICATIONS
Operating temperature
: 0°C to 50°C (32°F to + 122°F)
Temperature
measuring range (unit)
: 0°C to 50°C
(32°F to 122°F)
(probe)
: -50°C to 70°C
(-58°F to + 158°F)
Temperature resolution
(unit/probe)
: 1°C (2°F)
Humidity measuring range : 25 to 95% RH at 25°C (77°C)
Resolution of humidity
: 1% RH
Sensor wire length
: 3 meter
Dimension
: 117 X 107 X 20.5mm
(H x W x D)
Weight
: 174 g (without battery)
6

Publicidad

Tabla de contenido
loading

Tabla de contenido