Setting Balde Inclination To 45 - Sima POLYPANEL 125 Manual De Instrucciones

ENGLISH
10.2 SETTING BALDE INCLINATION TO 45°.
1. Disconnect the machine from the network and remove the blade
safeguard.
2. Remove the blade safeguard. Using a square located on the main and
reference in the face of the blade will observe the parallelism of the two.
3. Adjust it with the screws at each end by loosening its screws to get the
blade face is coincident with the vertical face of the square.
4. Having gained the position, re-tighten the nuts on the throttles and ride
the backup disk.
13