Maintaining The Guide Bar - Snapper SXDCS82 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MAINTENANCE
SiDE PLaTE anGLE
Maintain the depth gauge at a clearance of 1/32 in. (0.6 mm). Use a depth gauge tool for
checking the depth gauge clearances.
Every time the chain is filed, check the depth gauge clearance.
Use a flat file and a depth gauge jointer to lower all gauges uniformly. Use a 1/32 in. (0.6
mm) depth gauge jointer. After lowering each depth gauge, restore original shape by
rounding the front. Be careful not to damage adjoining drive links with the edge of the file.
Depth gauges must be adjusted with the flat file in the same direction the adjoining cutter
was filed with the round file.
Use care not to contact cutter face with flat file when adjusting depth gauges.
Depth Gauge Jointer

MainTaininG ThE GUiDE BaR

Every week of use, reverse the guide bar on the saw to distribute the wear for maximum bar life.
The bar should be cleaned every day of use and checked for wear and damage. feathering or
burring of the bar rails is a normal process of bar wear. Such faults should be smoothed with a file
as soon as they occur. A bar with any of the following faults should be replaced:
Wear inside the bar rails that permits the chain to lay over sideways
Bent guide bar
Cracked or broken rails
Spread rails
Lubricate guide bars weekly with a sprocket at their tip. Using a grease syringe, lubricate weekly in
the lubricating hole. Turn the guide bar and check that the lubrication holes and chain groove are
free from impurities.
Flat file
Lubricating hole
35
Restore
Original
shape by
Rounding
the front

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

1696773

Tabla de contenido