GreenWorks CS-80-XR-T Manual Del Propietário página 17

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION INSTRUCTION
LIMBING AND PRUNING
This unit is designed for trimming small branches and limbs up to 6 in. (15.2 cm) in diameter. For
best results, observe the following precautions:
Plan the cut carefully. Be aware of the direction in which the branch will fall.
Branches may fall in unexpected directions. Do not stand directly under the branch being cut.
The most typical cutting application is to position the unit at an angle of 60° or less, depending
on the specific situation. As the angle of the pole saw shaft to ground increases the difficulty
of making the first cut (from underside of limb) increases.
Remove long branches in several stages.
Cut lower branches first to allow the top branches more room to fall.
Work slowly, keeping both hands on the saw with a firm grip. Maintain secure footing and
balance.
Keep the tree between you and the chain while limbing. Cut from the side of the tree opposite
of the branch you are cutting.
Do not cut from a ladder; this is extremely dangerous. Leave this operation for professionals.
Do not make the flush cut next to the main limb or trunk until you have cut off the limb further
out to reduce the weight.
Following proper cutting procedures will prevent stripping the bark from the main member.
Do not use the pole saw for felling or bucking.
To prevent electrocution, do not operate within 50 ft. (15 m) of overhead electrical lines.
Keep bystanders at least 50 ft. (15 m) away.
17
(15 m)

Publicidad

Tabla de contenido
loading

Tabla de contenido