NAIM UnitiServe-SSD Guia De Inicio Rapido página 3

UnitiServe-SSD Quick Start Guide
With your UnitiServe-SSD connected to the network and its name entered in the web browser, its
Home
web interface menu will be displayed on the computer.
• The UnitiServe-SSD interface language can be changed. Select
System
menu, followed by
Home
by selecting the ( ) symbol.
• In order to rip CDs, a NAS drive must be enabled and given
Setup Home
on the menu followed by
network drives will be displayed. Select and
Return to the System Setup
Next
at the subsequent screen will display a list of enabled drives. Select the desired rip storage
drive followed by Next. If the drive is username and password protected, enter these, and select
Next. If it is not protected, leave the username and password boxes blank. Selecting
subsequent screen will give the NAS drive
3 R ippi ng Musi c
• Insert a CD into the loading slot.
• The UnitiServe-SSD will begin ripping automatically. To view progress, select
Home
the menu. The CD will be ejected automatically when ripping is complete. A typical CD will
take up to eight minutes to rip. To abort a rip and eject the CD briefly touch the front panel logo.
4 L ocal M us i c Playbac k
Browse Music
• Select from the
menu select an item and select
• Selecting the Quick Play
popular, recently played and newest items.
5 Ne t wor k M us ic Playbac k
• UnitiServe-SSD is a UPnP™ (Universal Plug and Play) server device. Ripped music is automatically
made available to any UPnP™ playback device connected to the network.
• Switch on a playback device and search through its list of connected servers for the UnitiServe-SSD
(e.g. NSSRV5E6F). Select the UnitiServe-SSD followed by the desired material for playback.
6 Sw itc hi ng O f f
• Switching off your UnitiServe-SSD from its rear panel power switch is not normally necessary.
• UnitiServe-SSD can be put into shutdown mode by touching the front panel logo for five seconds.
The logo will flash as UnitiServe-SSD shuts down.
To switch your UnitiServe-SSD back on from shutdown mode, the rear panel power switch must be
switched off and on again.
• Do not switch off UnitiServe-SSD from the rear panel power switch or disconnect it from mains
power until it is in shutdown mode.
Full installation and operational information can be found in the UnitiServe-SSD Reference Manual
included on the CD packed with the product, or available at www.naimaudio.com
Settings, Language,
and the desired option. Return to the Home menu
Network Shares
Enable
the desired drive.
menu and select Music Stores
Music Store
Home
menu and then either
Play.
menu from the Home menu provides short-cut access to the most
System Setup from the
Music Store status. Select
Manage Shares. A list of attached
and
followed by Add New Store. Selecting
Home
status. Return to the menu.
Ripping Monitor
Albums or Artists. From the following
Home
System
Yes at the
Note:
UnitiServe-SSD is able
to play CDs directly as well
as ripping them. CD play is
initiated from the System
from
Setup menu.
Note:
Ripping a CD you
do not personally own
may constitute a violation
of copyright law. You
must ensure, if inserting
a borrowed CD, that the
UnitiServe-SSD is configured
to play the CD only.
Note: To abort a rip and eject
the CD, touch the front panel
Naim logo.
Note:
UnitiServe-SSD may be
unable automatically to eject
CDs that are outside usual
manufacturing tolerances. If
this occurs, carefully insert
an unfolded paperclip into
the access hole beneath the
CD loading slot and push
to actuate the manual eject
mechanism.
Note: UnitiServe-SSD is only
able fully to catalogue ripped
CDs if it is connected to the
internet.
Note:
Music stored by
UnitiServe-SSD is not
automatically backed-up.
Network storage hardware
should be used for back-up.
See the Reference Manual.
English