Publicidad
Idiomas disponibles
Idiomas disponibles
9. FITTING THE UPPER
FOCUS BARS.-
Take the top left bar (13L) (marked
with the letter "L").
Insert the top bar onto the bottom left
focus bar (19L), lining up the letters
(L), Fig.9, fit the screws (99), the
washers (98-17) and tighten securely.
Now go through the same procedure
for the top right focus bar (13R).
10. FITTING THE FOCUS BAR
SIDE COVERS.-
Take the covers (12B and 12F),
marked on the inside with the letter
"R", and position them at the spindle
end with the bars on the right hand
side, as shown in Fig.9. Now use
screws (6) and (7) to attach them.
Carry out the same procedure at the
other end of the bar using the covers
(12B and 12F) marked on the inside
with the letter "L".
11.- FITTING THE MONITOR
SUPPORT.-
Plug connector (101), coming out of the
main post, into connector (80), coming
out of the boss (102) on the main body
(72), Fig.10. Now use the screws (99)
to attach them to the post.
12. FITTING THE ELECTRONIC
MONITOR.-
ATTACHING THE MONITOR.
Release screws (105), Fig.11, at the
back of the monitor (1).
Then connect terminals (101). The
handgrip terminals (9), Fig.11.
Next, slide the front of the monitor onto
the plate on top of the main post (102)
in the direction of the arrow, Fig.11,
push the cables down into the main
post making sure not the pinch any of
the cables. Replace the screws (105)
removed previously.
LEVELLING.-
Once the unit has been placed into its
fi nal position, make sure that it sits fl
at on the fl oor and that it is level. This
can be achieved by screwing the
adjustable feet (76) up or down, as
shown in Fig.12.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (96),
as shown in Fig.13, which make it
easier to move. The two wheels at the
front of the unit make it easier to place
the unit in to any chosen position by
lifting the rear slightly.
Store your unit in a dry place,
preferably not subject to changes in
temperature.
MAINS CONNECTION.-
Insert the jack for the transformer into
the connection hole on the main body
(bottom, rear of the machine) and then
plug the transformer (109) into a 220
V mains supply, Fig.14.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual).
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
19
Publicidad
